Painting can be a gruelling and time consuming task. With many people skipping it and paying for a professional because they find it too boring, painting your interior walls can also be an expensive way of improving the value of your home.

But what if you are not actually looking for a professional and want to get stuck in your self? What if it is your first time painting interior walls and you want to get it just right? Well alas my friends, as Real Home Improvement has you covered!

Below is a list of the equipment you are going to need in order to fully create beautifully painted walls:

- Suitable interior paint of a colour you like

- Small brush (for cutting in)

- Large Brush (or a roller and tray)

- Fine sand paper (for if you paint something by mistake and need to take it off when dried)

- Damp cloth

- Masking Tape

And thats it! The equipment listed above is on an as needed basis, with sand paper not really being ‘required’ but recommended as an extra tool for removing dried paint.

First step

The first step to painting your interior walls properly is to prepare the wall first using a damp cloth or sugar soap which you can mix at home or buy from any megastore. This is to remove and dirt, grime, debris or cobwebs from the surface before any paint is applied. It is also hugely important that you move any furniture away from the wall being painted, although if you can not do this then cover all your furniture which might become damaged with dust sheets to protect them from your fingers or the odd splatter of paint flying from your brush. On sensitive or particular areas such as door frames use masking tape to cover the edges to create a clean straight look to your finish.

Second Step

The base coat you apply to your wall is the most important as it sets the overall tone of the higher layers. Using a big brush, or as many people pot for a roller, swiper up and down in the same direction until the wall is completely covered and leave to dry. Note: It is very important that your first layer is not too thick and you make sure that there are no ‘loose’ fibres from your paintbrush stuck to the wall. Leave the wall to dry for approximately 90 minutes (unless otherwise specified) and go make yourself a cup of tea, or better, grab a beer (just joking, RHI can not be held responsible for you painting drunk ).

Third Step

Once your wall has dried and its first coat is there for all its glory, it is important to step back and decide whether or whether not you will need to apply one or two more coats to get the finish you need (this will save you money or time). If you are happy to proceed, then again take your roller to your wall and paint away, paying particular attention not to get paint on the ceiling. After the second coat is on, you can now set to work with a smaller brush cutting in on the ceiling (squaring the finish off).